Loading Events

« All Events

  • This event has passed.

LMI – Gocator Programming (IA – West)

March 14 @ 9:00 am - 2:00 pm CDT



Tickets are not available as this event has passed.


  • Introduction to 3D Profile MeasurementLMI Gocator Class
    • Sensor setup
    • 3D scan alignment
    • Setting up and applying 3D profile measurement tools for width and height
    • Using 3D measurement anchoring
  • Advanced 3D Profile Measurement
    • Exposure settings (single versus multiple)
    • Take intersect and angle measurements
    • Advanced 3D profile measurement tools such as Circle Fit and Panel (for gap and flush)
  • 3D Surface Measurement
    • Set up and apply 3D measurement tools
    • Surface height maps
    • Measure 3D features such as surface hole dimension, surface plane and surface stud
  • Sectioning
    • Extract a cross-section from a 3D model of a part
    • Perform basic measurements
    • Center and rotate a part for easy detection
    • Measurements on different profiles or sections

NOTES:  Lunch is provided


March 14
9:00 am - 2:00 pm
Event Category:


Iowa – West
Class locations are determined based on attendance. Exact location will be provided closer to the class date.
Omaha, NE 68119 United States